How to Blank or Cap R Table Cells Based on a Different Statistic Using R

This article describes how to go from a table with all cells being displayed...

...to one where any cell under a specified threshold has been removed or changed. In this example, the % is blanked based on the Count statistic being below 50:

Requirements

• A table showing multiple statistics with multiple rows/columns.
• A statistic to use for the threshold, such as Sample Size or Count.

Method

1. Go to Calculation > Custom Code from the toolbar.

2. Paste the below in the code editor:

#identify table that has the multiple statistics
table = table.Q5
#create a table of the statistic you want to show in the final result
#below shows the % statistic in the final table
tab1 = table[,,"%"]
#create a table of the statistics used to blank cells
#below uses the Count statistic
tab2 = table[,,"Count"]
#identify where the Count in tab2 is less than 50
#set the final results in tab1 to blank (using =NA)
tab1[tab2 <50] = NA
tab1

• The above code defines the table using the reference name from General > General > Name of your table. Change this as needed for your own document.
• It then defines tab1 as a table with only the percentages and tab2 as a table with only the counts.
• Finally, tab1 is returned, whereby any cells where Count is below 50 are made blank. You can change NA to a different value if you wish.

If your statistics are in the columns of your table, you can use the code below, which has a slightly different syntax for tab1 and tab2:

#identify table that has the multiple statistics
table = table.Q5
#create a table of the statistic you want to show in the final result
#below shows the % statistic in the final table
tab1 = table[,"%", drop=F]
#create a table of the statistics used to blank cells
#below uses the Count statistic
tab2 = table[,"Count", drop=F]
#identify where the Count in tab2 is less than 50
#set the final results in tab1 to blank (using =NA)
tab1[tab2 <50] = NA
tab1

3. OPTIONAL: Select this output and go to Appearance > Appearance in the object inspector to adjust decimal places, formatting, etc.

Next

How to Blank or Cap R Table Cells