Requirements
- A document containing two or more MaxDiff models.
Method
1. Select Anything > Advanced Analysis > MaxDiff > Ensemble of Models.
2. Select your MaxDiff models from the Input models drop-down list.
3. Check the Ensemble checkbox.
Note: If you don't tick the Ensemble box, Displayr will create a table that just compares the models. When this is the case, it is not necessary that the models use the same underlying data. If you do check the Ensemble box then Displayr creates an additional model. This requires that the underlying models all use the same data.
The table for my 3 models is shown below. The best values for each measure are shaded in dark blue and the worst are shaded in light blue.
Next
How to Use Hierarchical Bayes for MaxDiff
How to Create a MaxDiff Model Comparison Table
How to Create a MaxDiff Experimental Design
How to Save Classes from a MaxDiff Latent Class Analysis
How to Save Respondent-Level Preference Shares from a MaxDiff Latent Class Analysis
How to Convert Alchemer MaxDiff Data for Analysis in Displayr
Comments
0 comments
Article is closed for comments.